Hot tub hire requirements: power, water, space and access

Updated 6 November 2026 · By the Hot Tub Hire team

Short answer: To hire a hot tub you need a flat, level and firm surface that can take well over a tonne, a 13 amp outdoor socket protected by an RCD within reach of the tub without a standard extension lead, and a hose to fill it. Hard-shell tubs also need clear access, usually at least around 90 cm wide, from the road to the set-up spot.

Hot tub hire requirements: power, water, space and access

Power supply

A weatherproof 13 amp outdoor socket is ideal
The socket should be RCD protected
Do not use a standard extension lead
Some larger spas need a dedicated supply, which we will flag before booking

Base and space

Patios, paving and concrete bases are usually ideal. Lawns can work for inflatables if the ground is level and a protective base is used, but the grass underneath will suffer. Raised decking, roof terraces and balconies need to be checked for load.

Tub type	Typical space needed
4 person inflatable	About 2 m by 2 m plus working room
6 person inflatable	About 2.2 m by 2.2 m plus working room
Hard-shell spa	About 2.2 m by 2.2 m or more, plus access to the side panels

Water

You need an outside tap or a hose that reaches the tub. Filling a typical tub takes about an hour or two depending on water pressure.

Access

Measure the narrowest point on the route, including gates and side passages
Tell us about steps, slopes or tight corners
Hard-shell tubs are moved on their side and need more room than inflatables